| 螺杆空压机的工作过程详细分析 |
| 添加时间：2019/12/23 14:13:07 浏览次数： |
| 螺杆空压机的工作过程详细分析之进气过程：转子转动时，阴阳转子的齿沟空间在转至进气端壁开口时，其空间最大，此时转子齿沟空间与进气口的相通，因在排气时齿沟的气体被完全排出，排气完成时，齿沟处于真空状态，当转至进气口时，外界气体即被吸入，沿轴向进入阴阳转子的齿沟内。当气体充满了整个齿沟时，转子进气侧端面转离机壳进气口，在齿沟的气体即被封闭。 Detailed analysis of the working process of screw air compressor: when the rotor rotates, the groove space of the male and female rotors is the largest when it turns to the opening of the intake end wall. At this time, the groove space of the rotor is connected with the air inlet. Because the gas in the groove is completely discharged when the exhaust is completed, the groove is in a vacuum state. When it turns to the air inlet, the external gas is inhaled, Enter the groove of the male and female rotors along the axial direction. When the gas is full of the entire groove, the end face of the rotor inlet side turns away from the air inlet of the casing, and the gas in the groove is closed. 螺杆空压机的工作过程详细分析之排气过程：当转子的啮合端面转到与机壳排气口相通时，被压缩的气体开始排出，直至齿尖与齿沟的啮合面移至排气端面，此时阴阳转子的啮合面与机壳排气口的齿沟空间为0，即完成排气过程，在此同时转子的啮合面与机壳进气口之间的齿沟长度又达到最长，进气过程又再进行。 Detailed analysis of the working process of the screw air compressor exhaust process: when the meshing end face of the rotor is turned to be connected with the exhaust port of the casing, the compressed gas starts to exhaust until the meshing surface of the tooth tip and the tooth groove moves to the exhaust end face. At this time, the space between the meshing surface of the male and female rotors and the tooth groove of the exhaust port of the casing is 0, that is to say, the exhaust process is completed. At the same time, the meshing surface of the rotor and the air inlet of the casing are connected The length of the tooth groove between them reaches the longest again, and the air intake process goes on again. |
| 上一页 螺杆空压机气体泄漏 |
| 下一页 无油螺杆空压机是属于微型往复式活塞式压缩机 |
Copyright © 技术支持：遨游网络