| 空压机组成结构 |
| 添加时间：2019/8/9 11:44:17 浏览次数： |
| 1：:油循环系统 [2] 1:: Oil circulation system [2] 在启动前，首先启动油泵控制系统，油泵控制系统启动后保证空压机各润滑部件润滑良好，同时油泵控制系统可通过内置的温控阀来调节内部油压和油温，以满足系统需要。 Before starting, start the oil pump control system first. After starting, the oil pump control system ensures good lubrication of the lubricating parts of the air compressor. At the same time, the oil pump control system can adjust the internal oil pressure and oil temperature through the built-in temperature control valve to meet the needs of the system. 2：气路循环系统 [2] 2: Gas circulation system [2] 压缩机工作时，空气经过自洁式空气过滤器被吸入，通过PLC自动清洗过滤器，空气在经过进口导叶自动调节后进入一级压缩，经一级压缩后的气体温度较高，然后进入中间冷却器进行冷却(水走管内，气走管外，中冷器的水流量要求为110m/h)之后进入二级压缩系统，为避免系统中的气体倒入压缩腔内(避免带压起动)在压缩机的排气管道安装有一只悬挂全启式止回阀，压缩机排出的气体推开止回阀进入排气消声器，然后进入一级后冷器，二级后冷器，再进入排气主管道。 When the compressor works, the air is absorbed through the self-cleaning air filter, and the filter is cleaned automatically by PLC. After the air is automatically adjusted by the inlet guide vane, it enters the first stage of compression. After the first stage of compression, the gas temperature is higher, and then enters the intermediate cooler for cooling (water running in the pipe, outside the gas running in the pipe, water flow in the intercooler). It is required to enter the secondary compression system after 110 m/h. In order to avoid the gas in the system pouring into the compression chamber (avoid starting with pressure), a fully-open check valve is installed in the exhaust pipe of the compressor. The gas discharged by the compressor pushes the check valve into the exhaust muffler, and then enters the primary and secondary post-coolers, and then the exhaust muffler. Enter the exhaust main pipe. |
| 上一页 空压机特征特点 |
| 下一页 空压机种类 |
Copyright © 技术支持：遨游网络