保定空压机设备销售公司

Use and maintenance of desiccator

1、在装配或更换时应注意进出气口的连接

1, attention should be paid to inlet and outlet connections when assembling or replacing.

，如反装则干燥器不工作；

In the case of reverse loading, the dryer does not work.

2、产品在装配或更换时应注意管路的清洁，否则杂质会引起漏气；

2, when products are assembled or replaced, they should pay attention to pipeline cleaning, otherwise impurities will cause air leakage.

3、干燥罐应每年更换一次，如果使用环境的空气中含有过多的灰尘和水分，更换周期必须缩短。应定期检查贮气筒的积水状况（推荐每月一次），如果储气筒中积水严重，则必须更换干燥罐。干燥罐的更换方法：

3, the drying tank should be changed once a year. If the ambient air contains too much dust and moisture, the replacement cycle must be shortened. It iswww.qinggangbiesh.cn www.changchunbanjia.cn www.linpianjiaoni.com.cn www.liqingqi.com.cn www.shuidaoqiegeji.cn www.jianchajingm.cn necessary to regularly check the water status of the storage tank (recommended once a month). If the water in the storage tank is serious, the drying tank must be replaced. The replacement method of the drying tank:

a、卸下旧干燥罐，清洁连接螺栓及阀体；

A, unload the old drying tank, clean the connecting bolts and the valve body.

b、在新干燥罐与阀体的密封配合部位涂适量润滑脂，在新干燥罐与连接螺栓配合处涂螺纹紧固密封胶；

B, apply some grease to the sealing part of the new drying tank and the valve body, and thread the fastening sealant on the new drying tank and the connection bolt.

c、把新干燥罐拧于阀体上，最大拧紧力矩为15N ·m；

C, screw the new drying tank on the valve body, the maximum tightening torque is 15N. M.

4、本产品除干燥罐外,其他零部件用户不得随意拆卸；

4, the product can not be disassembled at any time except for the drying tank.

5、车辆在三级保养时，应由专业技工拆解清洗和整理，更换易损件；

5, when the vehicle is in level three maintenance, it should be dismantled, cleaned and sorted by professional technicians to replace vulnerable parts.

6、为了使干燥器的干燥性能良好，空压机与干燥器之间的连接要金属管并保持5m以上,防止因气体温度过高使干燥器中的橡胶件早期失效，进气口的温度应不大于65度。

6. In order to make the drying performance of the dryer well, the connection between the air compressor and the dryer is to keep the metal pipe and keep up to 5M. To prevent the early failure of the rubber parts in the dryer because of the high temperature of the gas, the temperature of the air inlet should not be more than 65 degrees.